Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G1023RL Series (Mfd. Since 02/21)
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for cutting.
2.
Adjusts blade tilt, if necessary, to correct
angle for desired cut.
Adjusts blade height no more than
3.
than thickness of workpiece.
4.
Adjusts fence to desired width of cut, then
locks it in place.
5.
Checks outfeed side of machine for proper
support and to make sure workpiece can
safely pass all the way through blade without
interference.
6.
Puts on safety glasses, respirator, and hear-
ing protection, and locates push sticks/blocks
if needed.
Starts saw.
7.
Feeds workpiece all the way through blade
8.
while maintaining firm pressure on workpiece
against table and fence, and keeping hands
and fingers out of blade path and away from
blade.
9.
Stops machine immediately after cut is
complete.
Refer to the instructions included with the Model
G1023RLW/RLWX router table for an overview of
router table operations.
1
⁄
" higher
4
-29-
Advertisement
Table of Contents
