Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G9743 (Mfd. Since 10/23)
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines the workpiece to make sure it is
suitable for cutting.
2.
Raises headstock, then closes feed on/off
valve to lock headstock in place.
3.
Adjusts vise angle, then securely clamps
workpiece in vise.
4.
Sets up work stop if needed for operation.
5.
Adjusts upper blade guide as close to
workpiece as possible, and verifies blade is
properly tensioned.
6.
Makes sure workpiece and machine are
stable and that there are no obstructions in
the way of cut.
7.
Puts on safety glasses and respirator.
8.
Ensures machine has adequate amount of
cutting fluid, then opens cutting fluid control
valve.
9.
Adjusts speed control knob to desired speed.
10. Starts blade and waits for blade to reach full
speed.
11. Turns ON coolant pump.
12. Opens feed on/off valve and adjusts feed rate
dial to lower headstock at desired speed into
workpiece to complete cut.
13. Once machine has stopped, raises head-
stock, disconnects machine from power, and
removes workpiece.
-25-
Advertisement
Table of Contents
