Table of Contents
Advertisement
4.8.1
Creating a command file
Create the command file and transfer it via TFTP to the local drive.
1. Create a new text file.
2. Rename it reboot or any of the other commands as seen above.
This file can have the .txt extension but can also be saved without
file extension.
3. Save and store it on your C: drive.
4. On a PC, go to START and RUN, then type cmd and hit Enter to
bring up the DOS command tool.
5. Make sure the tftp.exe process has access to the network and
then type following command but replace the IP address with that
of your DSP-1000:
tftp -i 192.168.11.25 PUT C:\reboot /reboot
6. Your DSP-1000 should now execute the command or as seen in
this example, reboot.
If you are not in the same network, make sure your router is
set up to forward the traffic on port 69 to your DSP-1000 and
NOTE:
the firewall will allow the traffic to pass through. Not all routers
support port forwarding, so you might not be able to access
the DSP-1000 unless you are on the same local network!
4.8.2
Multi command file
To change the volume, create a text file "multicmd.txt" and add either
"MUTE" to mute the sound or "Volume" plus a value from 1-32 on the first
line without extra line break. Transfer the file via TFTP or down.lst and the
setting will be changed immediately.
- 96 -
Advertisement
Table of Contents
