The firmware can also be updated via USB auto-copy or
NOTE:
remotely via HTTP/FTP download. See "Creating the
update.dsp List" for more details.
3.9 Wireless Connection
The DSP-1000 comes with an optional wireless kit. If installed, it can
connect wirelessly to the network using 802.11b or 802.11g. It supports
WEP and WPA encryption.
1. Make sure the wireless kit has been installed properly. The
antenna should be connected to the MAIN connector on the PCI
module.
2. Turn on your DSP-1000 and go to the Network category in the
Setup menu.
3. Set the Network Type to Wireless and press the ENTER key.
4. When changing from Wired to Wireless, a window will pop up for
you to enter the SSID and the WEP key. If the wireless
POWER SUPPLY FAILURE DURING FIRMWARE
UPDATE) THE PROCEDURE FAILS, YOU MAY NOT
BE ABLE TO OPERATE YOUR DEVICE ANY MORE.
- 38 -