Table of Contents
Advertisement
Turn on the device and wait for it to boot. Depending on the drive installed
and the network setup, this could take anywhere between 10 and 40
seconds. The DSP-1000 will only look for new network devices during
boot up. If you change any of the network related settings, restart the
device to ensure the new setup takes effect.
1. After the system has booted, you will see the main page on your
screen. To access your files, select the file type or use All Media
and press Enter. For the DSP-1000, select instead the location
where the files are stored and press Enter.
2. Select the directory where your files are stored and press Enter
to browse for your files. HDD is the local drive or CF cards, PC1/2
are links to a local network disk or computer and USB1/2 are the
drives attached to the USB ports.
Software Configuration
- 21 -
Chapter 3
3
Advertisement
Table of Contents
