Table of Contents
Advertisement
Network
1
Type
Automatic
2
IP
Address
IP
3
Address
MAC
4
Address
5
SSID
6
Link PC1
7
Link PC2
3.2 Misc1 Category
In this category, you can set the time using an NTP server via the internet.
Once the time is set, you can configure the playlist, download function
and schedule for these functions. Use the arrow keys on your remote
control for navigation and the ENTER button to configure the settings.
Select between Wired and Wireless network connection.
For the wireless function, you will need to have the
optional 802.11b/g wireless kit installed. When no
network connection is required, setting it to Off will
reduce the start up time.
Choose ON and the DSP-1000 will acquire the IP
address automatically at boot up or choose OFF and
configure the settings manually. You will be able to enter
the IP address, mask, gateway and DNS server. When
selecting Enhance, it will automatically obtain and IP
address but when it fails to do so, it will reboot about 30
seconds after start up and try again until an IP address
can be obtained.
Displays the current IP address of your DSP-1000. If
0.0.0.0 is shown, your device will not be able to connect
to the network. Restart the device or set the IP manually.
Displays the MAC address of your DSP-1000. This can
not be changed.
If you are using the wireless connection, this will display
your current SSID. Select it to change the SSID and if
required enter the WEP key.
Path to your remote network storage folder. Enter the IP
address of your computer or network disk and the shared
directory. Once this link is set, you can access the files
from the file library under PC1.
Path to your remote network storage folder. Enter the IP
address of your computer or network disk and the shared
directory. Once this link is set, you can access the files
from the file library under PC2.
- 23 -
Advertisement
Table of Contents
