Table of Contents
Advertisement
4
Scrolling Off
5
Volume
6
Mute
- System Command
1
Reboot
2
Refresh Content
3
Play List by Single
4
Play List by Date
5
Play List by Time
Play List by
6
Date/Time
7
Repeat Mode
8
Stop Auto Play
When changing the settings via remote commands, the GUI
will only be updated after a reboot. E.g.: After sending the
NOTE:
command to set the playlist to Date mode, the GUI will still
show the previous playlist mode until the device has been
rebooted.
A.3 Message Control
Start the configuration tool and select the Message Control tab. Right
click in the field on the left hand side to add the IP address of your
DSP-1000. Once listed, click on it to select the unit and then send the
message to update the scrolling text on the DSP-1000.
Turns the scrolling text message OFF.
Changes the volume level.
Mutes the audio output.
Reboots the device.
Refreshes and updates current playlist and
content.
Sets playlist to Single mode.
Sets playlist to Date mode.
Sets playlist to Time mode.
Sets playlist to Date/Time mode.
Turns on the Repeat mode.
Stops playback.
- 104 -
Advertisement
Table of Contents
