Table of Contents
Advertisement
4. At this time, the date will still show 1970, so press the SETUP key
on your remote control to exit the setup menu and then reboot
the device. Turn off the power switch, wait a few seconds and
turn it back on.
5. After reboot, go back to the Misc1 category in the setup menu to
check if the date and time are correct.
If it does not work, try some of the following tips:
• Reboot the unit by turning off the power switch and try again.
• Make sure the unit has access to the internet.
• Set the IP and DNS address manually.
- 42 -
Advertisement
Table of Contents
