End Of Life; Removing The Product From Use; Recycling And Waste Disposal - Halton Safe Management 2.0 Installation, Commissioning, Operating, And Maintenance Manual

Halton Safe Management 2.0 (SM2) - Installation, commissioning, operating, and maintenance guide

8 End of life

8.1 Removing the product from use

1. Disconnect the power cable of the Halton Safe Management 2.0 controller from the socket.
2. Disconnect the wiring.
3. Dismount the components of the system.

8.2 Recycling and waste disposal

Carry out all recycling and waste disposal in accordance with the law and regulations of each country. Observe the
specific requirements enforced by the legislation and local authorities of each country. Keep the environment clean.
Packaging waste
Packaging materials that can be recycled are listed below. They must be disposed of in conformity with existing
local regulations.
▪ Polyethylene: outer protective film
▪ Cardboard: angle protections, cardboard boxes etc.
▪ Wood: pallet, plywood etc.
Electronic and other components
Any electronic and other corresponding components of the product should be assessed for the most suitable
recycling route in accordance with local regulations.
Recycling after decommissioning
Recycle the product and its components upon decommissioning. Follow the local laws and regulations when
disposing of electrical components and steel materials. The following instructions are general.
▪ Disconnect and dismount all electrical and/or pneumatic components (such as actuator, junction box,
switches, cables etc.).
▪ Recycle electronic and other corresponding components of the product in accordance with WEEE provisions.
▪ Recycle the steel frame and steel parts in accordance with steel recycling provisions.
If you require more details for recycling and waste disposal concerning a product, contact Halton.
1.0 All rights reserved ©Halton
62