Setting The Time And Date; Setting Up The Test Schedule - Halton Safe Management 2.0 Installation, Commissioning, Operating, And Maintenance Manual

Halton Safe Management 2.0 (SM2) - Installation, commissioning, operating, and maintenance guide
If you get errors when doing the task, see Troubleshooting.

5.3.13 Setting the time and date

Here you set the time and date of the system. You can also change the time zone or modify other clock-related
settings.
1. Log in as Installer. For instructions, see
2. In the upper left corner of the view, select "Settings" from the drop-down list.
3. From the lower drop-down list, select "Clock". The clock settings view opens.
4. Set the correct time and date.
5. If needed, change the time zone or modify other clock-related settings.
6. On the left-hand side of the view, select "Change".
7. To exit the Settings mode, in the upper left corner of the view, select "Usermode" from the drop-down list.

5.3.14 Setting up the test schedule

Here you set up the test schedule for automatically testing alarm groups (zones) at specified times. You can set six
events per day.
Note: To ensure proper operation of fire dampers, inspection must be carried out regularly according to local
building codes. The minimum recommended inspection period is every 6 months. Save the inspection
documentation for future needs.
1. Log in as Installer. For instructions, see
2. Select the zone settings icon.
3. In the Zone settings view, at the lower part of the view, select "Test Timetable".
1.0
Logging in as Installer.
Logging in as Installer.
All rights reserved ©Halton
35