Configuring A Smoke Detector Or An Alarm Device - Halton Safe Management 2.0 Installation, Commissioning, Operating, And Maintenance Manual

Halton Safe Management 2.0 (SM2) - Installation, commissioning, operating, and maintenance guide
Value
All
-
Unit
Single
Zone [number]
4. In the Dampers view, configure the location (name) of each fire damper. For instructions, see
unit.
If you get errors when doing the task, see Troubleshooting.

5.3.6 Configuring a smoke detector or an alarm device

Here you connect a smoke detector or an alarm device that has an NO or NC connector to an alarm group (zone).
You also need to configure the location (name) and type of these devices.
1. Log in as Installer. For instructions, see
2. Select the smoke detector icon.
Note: The icon is grey if no units have been configured.
3. In the Smoke Detectors view, configure the zone information for each smoke detector or alarm device. For
instructions, see Connecting a unit to an alarm group
4. In the Smoke Detectors view, configure the location (name) for each smoke detector or alarm device. For
instructions, see Renaming a
5. In the Smoke Detectors view, set the type of each smoke detector or alarm device. For more detailed
instructions, see Setting the type of a
1.0
Logging in as
unit.
unit.
All rights reserved ©Halton
Description
The fire damper impacts all units.
No impact
The fire damper impacts a link unit.
The fire damper impacts a single fire damper.
The fire damper is not closed with an external
command except in a test situation and by an
external fire alarm, if set accordingly.
The fire damper impacts zone [number].
Installer.
(zone).
24
Renaming a