Table of Contents
Advertisement
PIT es Set10u-5ns (AIDA) basic
Triggered: The E-STOP device is in active state, the actuator has been pressed and it is
}
therefore locked. The two safety circuits are opened (fully operated). The actuator is illu-
minated red, the bevelled protective collar flashes yellow.
Installation
Prepare two fixing holes for M4 screws on the mounting plate.
}
Undo the four cross head screws on the housing faceplate and remove the housing face-
}
plate.
Use M4 screws to attach the housing subplate. Use an appropriate screw adhesive (e.g.
}
Loctite) to protect the screws from working loose.
Place the housing faceplate back on the housing subplate and screw them in place.
}
Operating Manual PIT es Set10u-5ns (AIDA) basic
1004863-EN-03
CAUTION!
Always install the device with the supply voltage switched off.
6.5
59
NOTICE
In an open state, the electronics contained within the housing are no longer
protected against environmental influences. In particular you should avoid
humidity, electrostatic discharge and the ingress of foreign bodies.
Housing
base area
| 11
Advertisement
Table of Contents
