Safety; Intended Use - Pilz PIT es Set10u-5ns (AIDA) basic Operating Manual

PIT es Set10u-5ns (AIDA) basic

Safety

Intended use

The E-STOP function is triggered by operating the active E-STOP device and the voltage to
the evaluation device is interrupted (dual-channel, fully operated).
In active state, the E-STOP device PIT es Set10u-5ns (AIDA) basic is lit (the actuator lights
up red) and it fulfils the requirements in accordance with EN ISO 13850.
In inactive state, the E-STOP pushbutton PIT es Set10u-5ns (AIDA) basic is not lit and it
can not be detected as an emergency stop device. The E-STOP function is deactivated.
The safety function of the E-STOP device is:
Ensuring that the red lighting can be detected under defined environmental conditions.
}
In case of a lighting failure of the active E-STOP device's lightings, the E-STOP function
is triggered and the voltage to the evaluation device is interrupted (single-channel, par-
tially operated).
Operating Manual PIT es Set10u-5ns (AIDA) basic
1004863-EN-03
CAUTION!
It must not be possible to defeat the E-STOP pushbuttons. Otherwise ma-
terial damage and severe injuries may result, depending on the application.
The E-STOP pushbutton must not be used in place of other safety meas-
ures.
WARNING!
Loss of the safety function by deactivating the E-STOP device
Deactivating the E-STOP device may result in serious injury and death.
The E-STOP function can only be deactivated when the plant/machine is in
an operating mode that does not become dangerous to the operator, or
when the safety function is implemented by other measures.
NOTICE
The E-STOP device must be used only in the inner area and it must be pro-
tected from direct sunlight. Its brightness covers the scope of the workplace
regulations ASR A3.4 for common industrial environment.
NOTICE
The E-STOP device must not be used in an atmosphere with a high degree
of hydrogen sulphide (H S), e.g. in sewage plants and farms.
2
| 7