Table of Contents
Advertisement
Kerotest Manufacturing – SHANNON & PAF III OPERATORS MANUAL - REV 3
The information contained herein is the technical data and specifications for the following Kerotest
Electrofusion Processors:
•
Shannon USB
•
Shannon Bluetooth
•
Portafuse III
This publication was written to assist trained personnel in the proper procedures and operating functions of a
Kerotest Electrofusion Processor.
Operation of KEROTEST MANUFACTURING CORP equipment should only be performed by trained and
qualified personnel.
The technical data and advice contained herein is based upon tests and information believed to be reliable.
However, the operator should not rely upon it absolutely for specific applications. All data is given and
accepted at the user's risk and confirmation of its validity and suitability in particular cases should be obtained
independently. KEROTEST MANUFACTURING CORP makes no guarantee of results and assumes no obligation
or liability in connection with its advice. The integrity of the piping system is the ultimate responsibility of the
installer. This publication is not to be taken as a license to operate under, or recommendation to infringe, any
patents.
Kerotest Electrofusion Processors are reliable, easy-to-use, rugged tools designed to withstand conditions
found at typical construction sites throughout the world.
Kerotest Electrofusion Processors are splash proof and highly shock resistant.
Kerotest Electrofusion Processors can fuse all manufacturers' fittings requiring outputs that are within the
voltage and current values listed in the Specifications Table on page 8.
Kerotest Electrofusion Processors operate most efficiently and reliably in the Barcode Fusion Mode; however,
they can be operated in Alternate Fusion Modes. The Barcode Fusion Method is always preferred and should
be used whenever possible.
Kerotest Electrofusion Processors have an intuitive user interface that is easy to learn.
Kerotest Electrofusion Processors are equipped with internal memory for data storage and can be
downloaded to determine installation conditions and fusion cycle status.
Kerotest Electrofusion Processors are capable of scanning and recording both ASTM F2897-11 and ISO 12176-
4 Traceability barcodes.
Shannon Electrofusion Processors can be operated from any AC power source meeting the input power
requirements listed in the Specifications Table on page 8.
The Portafuse III Electrofusion Processor is powered by a 48 volt 9ah lead acid battery pack and is capable of
fusing all fittings with a current requirement of 35 amps or less.
INTRODUCTION
Preface
Features
Page 6 of 60
Advertisement
Table of Contents
