Table of Contents
Advertisement
Kerotest Manufacturing – SHANNON & PAF III OPERATORS MANUAL - REV 3
If no errors were encountered during the fusion process, the following screen will be displayed:
If errors were encountered during the fusion process, an Error Code Message will be displayed (see page 53
for a list of possible Error Codes), and the following screen will be displayed after the error message screen:
After the Output Lead Ends are disconnected, the Kerotest Electrofusion Processor will retu rn to the
CONNECT FITTING screen and will be ready to accept information for the next fusion.
NOTE:
If Operator Traceability is enabled, remember that the Operator ID codes entered previously will remain
attached to any additional fusions until the power is shut off or until the information is changed by the
operator.
DISCONNECT
OUTPUT LEADS
FUSION COMPLETED
Successfully
DISCONNECT
OUTPUT LEADS
FUSION NOT COMPLETE
Errors Encountered
Page 31 of 60
Advertisement
Table of Contents
