Table of Contents
Advertisement
Kerotest Manufacturing – SHANNON & PAF III OPERATORS MANUAL - REV 3
The Features Menu is accessed by holding the UP and DOWN buttons at the same time when the processor is
first powered up. Keep holding the UP/DOWN buttons through the INTERNAL SELF TEST screen, until the
processor displays a screen similar to the following:
Use the UP/DOWN buttons to highlight the desired option. Press the START button to access the desired
option. Press the STOP button to return to normal operation.
Traceability
This setting controls the Pipe/Fitting Traceability functions. Values are "OFF", "ON" or "OPT":
•
"OFF" disables the Pipe/Fitting Traceability function.
•
"ON" enables the Pipe/Fitting Traceability function. The machine WILL NOT allow a fusion to
proceed unless at least one (1) traceability barcode is scanned.
•
"OPT" (Optional) enables the Pipe/Fitting Traceability function but will allow a fusion to proceed if
the operator decides not to scan a traceability barcode.
When Option 1 is highlighted, press the START button to select it. Use the UP/DOWN buttons to toggle
through available Pipe/Fitting Traceability function values. When the desired value is displayed, press the
START button to save.
PIPE AND FITTING TRACEABILITY WILL ONLY APPLY TO FUSIONS DONE IN BARCODE MODE.
To learn more about Pipe and Fitting Traceability, contact an authorized representative (See page 19).
Features Menu
FEATURES
1. Traceability
Page 35 of 60
OFF
Advertisement
Table of Contents
