Table of Contents
Advertisement
Kerotest Manufacturing – SHANNON & PAF III OPERATORS MANUAL - REV 3
Pressing and holding down the UP button while the processor is at the CONNECT FITTING screen will show a
screen similar to the following:
This screen shows the following information:
•
Software version of the processor (In this case, version 1.2.3).
•
Processor serial number (In this case, 9690123).
•
SMART Scanner™ status (In this case, ON).
•
The number of fusions the processor has completed (In this case, 124).
•
The Date and Time (In this case, May 11, 2018 at 3:30 PM)
•
The date the processor will be due for calibration (In this case, May 11, 2021)
Release the UP button to return to the CONNECT FITTING screen.
To begin the fusion process, follow the instructions in the following section that corresponds to the fusion
method that you wish to perform.
**The Barcode Fusion Method is always preferred and should be used whenever possible.
When beginning a Barcode Fusion, start from the CONNECT FITTING screen.
Secure the correct fitting adapters to the Output Lead Ends.
Connect both Output Lead Ends to the fitting.
When the Output Lead Ends are connected to the fitting, the processor will measure the fitting resistance and
display a screen similar to the following:
After measuring the fitting resistance, the processor will display the following screen:
1.2.3
SW: ON 03
05/11/2018
CAL DUE – 05/11/2021
Barcode Fusions
VERIFYING
RESISTANCE
10.198
SCAN BARCODE
Page 24 of 60
SN:9690123
FC:0124
15:30
Advertisement
Table of Contents
