Table of Contents
Advertisement
Kerotest Manufacturing – SHANNON & PAF III OPERATORS MANUAL - REV 3
Downloading to a USB Flash Drive (USB models only)
Fusion data from a Kerotest USB Electrofusion Processor is downloaded onto an external USB flash drive. The
data is output in a binary format that is compatible with a free macro-enabled Excel Spreadsheet available
from KEROTEST MANUFACTURING CORP.
To download fusion data from the processor to a USB flash drive, perform the following steps:
1.
Turn ON the processor and allow it to proceed through the INTERNAL SELF TEST until it reaches the
CONNECT FITTING screen.
2.
Plug a formatted USB flash drive into the USB host connector on the face of the processor.
3.
The USB flash drive will be detected automatically and the fusion data will be written to the drive.
4.
A progress screen similar to the following will be displayed as the download proceeds:
5.
After the download is complete, the processor will return to the CONNECT FITTING screen. You
may now disconnect the USB flash drive from the USB Host Port to resume normal operation.
ONLY NEW FUSIONS PERFORMED SINCE THE LAST DOWNLOAD WILL BE WRITTEN TO THE DRIVE.
THE USB FLASH DRIVE MUST BE FORMATTED USING FAT OR FAT32 WITH A SECTOR SIZE OF 512 BYTES.
Serial Processors
Some Kerotest Electrofusion Processors may have a 9 pin D-sub connector instead of a USB host connector.
To download fusion data from a serial processor onto a USB flash drive, you will need a USB to Serial Port
adapter. This adapter is available for purchase from KEROTEST MANUFACTURING CORP. One adapter may be
used with multiple processors.
The pictures below show a 9 pin D-sub connector and the installed adapter for your reference:
9 Pin D-Sub
Connector
DOWNLOADING DATA
48%
USB Host
Page 46 of 60
Adapter
Installed
Advertisement
Table of Contents
