Changing Registered Device/ Main Board; Check The Network Environment; Switch To Paas Mode; Overwrite Registration On Server - Ricoh P C300W Field Service Manual

Changing Registered Device/ Main Board

To change the PaaS registered device or if the EGB has been replaced, follow the procedure below on
the new device.
The existing customer Contract ID and customer authentication key are required for authentication.
Note: It is not necessary to obtain a new contract ID and authentication key to change a registered
device or EGB.

Check the Network Environment

Specify the network settings (IP address, Subnet mask, Gateway, and DNS) in the following menu:
1.
Open User Tools > Network Settings > IPv4 Configuration, specify the IP address, Subnet,
Gateway, DHCP, and DNS settings according to the customer's network environment.

Switch to PaaS Mode

Enter the SP mode.
1.
For information on how to enter the SP mode, contact the supervisor in your branch office.
Set the "PaaS Validity Setting" to active.
2.
Printer model: CTL Maintenance > PaaS Validity Setting
MF model: CTL SP > PaaS Validity Setting

Overwrite Registration on Server

Make sure the machine's main power is always turned on and connected to the internet during
registration.
4.Setting for PaaS (Only for CHN)
19