Ricoh P C300W Field Service Manual page 162

5.System Maintenance
Temp.before 2cycles
Temp.before 3cycles
Fuser SC Fusing SC Reset
Reset
Hard High Temp. Detection
Init Engine EEPROM
Special Mode
PM Parts Notice
150
Menu
Press Left
Press Right
Heat Center
Heat NC
Press Center
Press Left
Press Right
Heat Center
Heat NC
Press Center
Press Left
Press Right
Description
current SC code.
Displays the temperature (°C) of
each sensor at the occurrence of
the 2nd fusing SC code before the
current SC code.
Displays the temperature (°C) of
each sensor at the occurrence of
the 3rd fusing SC code before the
current SC code.
Resets the fusing related SC.
Resets the fusing related SC when
high-temperature detected error
(hardware) occurred.
Execute this to initialize a new
EEPROM. Turn the machine power
off/on after you execute this
setting.
Also, the following items are
cleared by EEPROM initialization:
•
Machine total counter (total
page, full color, and BW)
•
Error log (listed as "Call
Service" on Maintenance
Page)
•
Duplex page counter
(DFU)
Sets whether to display the PM
parts replacement notice and
whether to stop the engine.
[0 to 3 / 2 / 1/step]
•
0: At near end: No notice, At
life end: Notice "Replace Now"
•
1: No Notice
•
2: At near end: Notice, At life