Sc 9Xx (Other Error) - Ricoh P C300W Field Service Manual

6.Troubleshooting
SC No. Type
31
SC681- D The requested buffer is full (M)
32
SC681- D The requested buffer is full (C)
33
SC681- D The requested buffer is full (Y)
34
SC681- D Verification error (K)
36
SC681- D Verification error (M)
37
SC681- D Verification error (C)
38
SC681- D Verification error (Y)
39
An error is notified during the ID identification after three retries.
•
•
•
Check if the SC occurs by turning the power OFF then ON. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power after each
step.
1.
2.
3.
4.
5.

SC 9XX (Other Error)

SC No. Type
SC990- D Software performance error
00 The software attempted to run an unexpected operation.
•
•
•
•
220
Error Name/Error Condition/Major Cause/Solution
Malfunction
Noise
ID chip contact failure
Check if there is any dirt or abnormality on the ID chip connector. Clean the
connector if it is dirty or replace the ID chip for any abnormalities.
Replace the ID chip board (PCB6).
Replace the AIO.
Replace the harness between the EGB (PCB1) and ID chip board (PCB6).
Replace the EGB (PCB1).
Error Name/Error Condition/Major Cause/Solution
Incorrect argument
Incorrect internal parameter
Insufficient working memory
Abnormal performance caused by an error that cannot be detected in normal