Enter Demo Mode; Clear Demo Mode; Error Codes - Electrolux EID200QSW00 Technical & Service Manual

Diagnostic System

10.7 Enter Demo Mode

To enter Demo mode, follow the instructions mentioned below:
• Switch ON the machine via Power button;
• Turn the selector in the 6th position from the top clockwise;
• Simultaneously hold Temp and Set for 3 seconds;
• The message dn blinks 3 times on cycle time digits;
• If no acknowledgement is received, switch the machine OFF and repeat the sequence from the beginning.
NOTE
Every time the machine is switched ON, Demo mode is automatically recalled; this occurrence is signaled
at the start-up by the text dn flashing 3 times on cycle time digits. Unplugging the unit will not clear Demo
mode.

10.8 Clear Demo Mode

To clear Diagnostic mode, follow the instructions mentioned below:
• Redo the Enter Demo Mode sequence of actions described above or go to the next
step.
• Press the Reset to Factory Default combination (Dry Level + Options keys anytime).
• If the action is acknowledged, the machine reboots in Normal mode.

10.9 Error Codes

Code
0x21 Condense Pump Error
0x22 Condense Pump Sensing Error
0x31 Conductimetric Sensor Frequency Too High
0x32 Conductimetric Sensor Frequency Too Low
0x45 Door Closed Sensing Error
0x55 FCV Safety Error
0x56 FCV Motor Plug Not Connected
0x57 FCV Current Trip Failure
0x58 FCV Over Current Failure
0x59 FCV Motor Not Following
0x5A FCV Board Overheating
Full Name
42
Enabled in Setup
Yes
Yes
No
No
Yes
No
No
No
No
No
No
Page
no.
44
45
45
45
46
46
47
47
47
48
47