Main Control Board - Electrolux EID200QSW00 Technical & Service Manual

2. Rotate the Drum in either direction until you spot
the location of 3 screws on the Drum, that holds the
Drum Vanes with the Drum (See Fig. 31).
3. Remove all the screws to take out the Drum Vanes
(See Fig. 32).
Fig. 33 - Drum Vane
Serviceable Component Accessibility
Fig. 31
Fig. 32
Steps to assemble the Drum Vanes:
1. Rotate the Drum in either direction until you spot
the location of 3 screws on the Drum that hold Vane
with the Drum and tighten these screws (See Fig. 31).
2. Align the Vane inside the Drum in its screw
position (See Fig. 34).
3. Reassemble the Top Panel (Refer last 4 steps of
Control Panel Assemble Procedure).

9.4 Main Control Board

Steps to disassemble the Main Control Board:
1. For disassembling the Main Control Board,
remove the Top Panel (Refer first 4 steps of Control
Panel Disassemble Procedure).
2. Remove the 4 screws from the Rear Panel (See
Fig. 35).
21
Fig. 34
Fig. 35