Motor Assembly; Fig. 59; Remove The 3 Screws (See Fig. 41) - Electrolux EID200QSW00 Technical & Service Manual

9.6 Motor Assembly

Permanent Magnet DC Motor
In a DC motor, an armature rotates inside a
magnetic field. Working principle of DC motor is that
whenever a current carrying conductor is placed
inside a magnetic field, there will be a mechanical
force experienced by that conductor. Hence for
constructing a DC motor it is essential to establish a
magnetic field (generated by magnet). The magnet
can be of any type i.e. electromagnet or permanent
magnet. When permanent magnet is used to create
magnetic field in a DC motor, the motor is referred
as permanent magnet DC motor. These types of
motors are essentially simple in construction and
are used as starter motor in automobiles, windshield
wipers, washer, toys and so on. As the magnetic field
strength of a permanent magnet is fixed, it cannot be
controlled externally. Field control of this type of DC
motor is not possible.
Steps to disassemble the Motor Assembly:
Step: 1
1. For disassembling the Motor Assembly, remove
the Top Panel (Refer first 4 steps of Control Panel
Disassemble Procedure).
2. For disassembling the Motor Assembly, remove
the Right Side Panel (Refer first 4 steps of Main
Control Board Disassemble Procedure).
3. Location of Belt Drive is shown in figure below
(See Fig. 57).
Serviceable Component Accessibility
Fig. 57
4. Rotate the Belt in clockwise direction and push
slightly in the marked direction simultaneously to take
Belt out of the Motor Shaft (See Fig. 58).
Fig. 58: Right Side View
without Right Panel
Step: 2
1. Remove the 3 screws that hold Fan Wheel Covers
(See Fig. 59).
2. Unplug the connector and release the spring (See
Fig. 60).
25

Fig. 59

Fig. 60