0X71: Drying Ntc Error - Electrolux EID200QSW00 Technical & Service Manual

0x71: Drying NTC Error

0x71
NTC1 failure or Wiring defective or Main Board defective.
Checks to perform:
Is the resistance measured
between J9-4 and J9-5 Connector
terminals 5.3 KΩ ± 5%? (See Fig.
143)
Y
E
S
Is the wiring between Main Board and NTC1
terminals connected properly?
Y
E
S
Replace the Main Board and repeat the diagnostic
cycle to check for any further errors.
Fig. 143: Resistance Measurement on J9 5-Pin
Connector
Troubleshooting Based on Error Codes
Is the resistance measured directly
on NTC1 terminals 5.3 KΩ ± 5%?
NO
(See Fig. 144)
Check / Replace the wiring and repeat the diagnostic
Check / Replace the wiring and repeat the diagnostic
NO
51
WARNING
Check that all the connectors are correctly
inserted.
NO
Y
E
S
cycle to check for any further errors.
cycle to check for any further errors.
Fig. 144: Resistance Measurement on NTC1
0x71
Replace the NTC1 and
repeat the diagnostic
cycle to check for any
further errors.