29. Note: For clarity, the Shrouds are not shown
in this step.
Thread an M12 Nut (84) all the way onto the
High Cable (55).
Place a Large Washer (85) on top of the Weight
Tube (24).
Tighten the High Cable (55) into the Weight
Tube (24) until all the slack is removed from the
cables.
Tighten the M12 Nut (84) against the Large
Washer (85).
Seat Assembly
30. Attach the Backrest (16) to the Lower Upright
(93) and the Upper Upright (3) with two M6 x
63mm Screws (70) and two M6 Washers (82).
31. Attach the Seat (15) to the Seat Frame (6) with
four M6 x 16mm Screws (62) as shown.
29
30
16
31
15
Wide
End
6
20
55
84
85
24
3
70
82
93
70
82
62