Gold's Gym XR 45 User Manual page 18

23. Attach the Low Cable (53) to the U-bracket (45)
with an M8 Washer (59) and an M8 Locknut
(58).
See the inset drawing. Do not overtighten
the M8 Locknut (58); it should be threaded
onto the end of the Low Cable (53) so that
only two threads are showing above the
Locknut.
24. Identify the High Cable (55). Route the High
Cable upward through the Top Frame (4) and
over a Pulley (48).
Attach the Pulley (48) inside the Top Frame (4)
with an M10 x 67mm Bolt (71), two M10
Washers (57), two 13mm Spacers (52), and an
M10 Locknut (56).
25. Route the High Cable (55) over a Thin Pulley
(47) and downward through the Top Frame (4).
Attach the Thin Pulley (47) inside the Top
Frame (4) with an M10 x 67mm Bolt (71), an
M10 Washer (57), and a 13mm Spacer (52).
Make sure that the Thin Pulley does not fall
out of the Top Frame while you complete
steps 26 and 27.
23
58
59
45
58
53
24
56
52
57
25
18
45
53
55
4
48
52
71
57
47
4
55
52 57
71