Recommended Installation Tools; Unpacking & Handling - Will Burt Night Scan Chief Series Operating Instructions Manual

NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
Saddle: 35 lb (16 kg)
(single point load in center)
Figure 5-1 Night Scan Chief Reaction Loads on Mounting Structure
5.2

Recommended Installation Tools

Table 5-1 lists recommended tools and materials for installation.
Table 5-1 Recommended Installation Tools & Materials
Safety Glasses
Hard Hat or Helmet
Wrenches
Torque Wrench
Wire Cutter/Stripper
Shop Rags
Note: Depending on the national and local standards and codes of practice, and the environ-
ment, additional personal protective equipment may be necessary.
5.3 Unpacking & Handling
Unpack and handle the items as follows:
1. Carefully remove all the small cartons from the large crate or carton.
2. Remove all the items from the small cartons.
3. Ensure all components are included and that the required tools are readily available.
4. Inspect for any shipping damage. If damage has occurred, notify the carrier.
PAGE 22 OF 80
200 lb (91 kg)
(load at each mounting hole)
Tools and Materials
Safety Gloves
Hearing Protection
Screwdrivers
Drill
RTV Silicone
Hoist (minimum 500 lb (227 kg)
(load at each mounting hole)
Safety Shoes
Crimping Tool or Solder Set
Multimeter (to verify power is turned off)
Knife or Scissors to Cut Crate Band
1/2 inch or M12 Mounting Hardware (6 each)
575 lb (261 kg)
TP-4602001-T
DECEMBER 2020