Machine Settings; Technical Specifications - Electrolux TW SL6 E User Manual

er. Do not operate the dryer when missing o-
ring gasket on door light cover.
Warning! For safety reasons, the cover
must be screwed down tightly. If this is

Machine settings

Setting
BUZZER permanent off
Water hardness
Water contains, a variable quantity
of limestone and mineral salts of
which quantities vary according to
geographical locations thus vary-
ing its conductivity values.
Relevant variations of the conduc-
tivity of the water compared to
those prefixed by the factory could
slightly influence the residual hu-
midity of the laundry at the end of
the cycle. Your dryer allows you to
regulate the sensitivity of the drying
sensor based on conductivity val-
ues of the water.
Emptying water tank - warning
message permanent off
When using an external drain for
the condensed water.

Technical specifications

Parameter
Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
not done, the dryer must not be
operated.
Implementation
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (Trockengrad) and
RPM (U/Min.) buttons and hold down for approx. 5 sec-
onds.
3. The buzzer is by default always off. You can use BUZZER
(Signal) button to activate or deactivate sound but ma-
chine does not memorize your selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (Trockengrad) and
TIME (Zeitwahl) buttons and hold down for approx. 5
seconds. The current setting is on the display:
–
low conductivity <300 micro S/cm
–
medium conductivity 300-600 micro S/cm
–
high conductivity >600 micro S/cm
3. Press the Start/Pause button sequentially until you set
desired level.
4. To memorize setting press simultaneously the DRY-
NESS (Trockengrad) and TIME (Zeitwahl) buttons or turn
knob to OFF (AUS) position
1. Turn the programme selector to any programme.
2. Press simultaneously the RPM (U/Min.) and TIME (Zeit-
wahl) buttons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
icon and
off
– warning
icon and
switched on
By default the warning message is switched on and
displayed always at the end of the drying cycle or dur-
ing the cycle if the water container is full.
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
electrolux 17
- warning message is
- warning message is
Value