Machine Settings - Electrolux TK 5357 F User Manual

Parameter
COTTON CUPBOARD DRY
COTTON IRON DRY
SYNTHETICS CUPBOARD DRY
1) Different loading volume data may be needed in some countries as a result of different measuring methods.
2) In accordance with EN 61121.
3) Hints for test institutes: cycle has to be checked in accordance with EN 61121.

Machine settings

Setting
Buzzer permanent
on/off
1)
Water hardness
Emptying water res-
ervoir - warning LED
2)
off
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical
locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those
prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer
allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir is
full. When using an external drain for the condensed water warning can be offi
Service
In the event of technical faults, please first check
whether you can remedy the problem yourself with
the help of the operating instructions - see chapter
What to do if....
3)
3)
3)
1. Turn the programme selector to any programme.
2. Press simultaneously the Delicate (Schon) and Long anti-crease (Knitter-
schutz Plus) buttons and hold down for approx. 5 seconds.
– diode above Buzzer (Signal) button starts lighting - buzzer permanently
on.
– lighting diode comes off - buzzer permanently off.
3. The buzzer is by default always off. You can use the Buzzer (Signal) button
to activate or deactivate sound but the machine does not memorise your
selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the Delicate (Schon) and Time (Zeitwahl) buttons
and hold down for approx. 5 seconds. The current setting is on the dis-
play:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the Start/Pause button sequentially until you set desired level.
4. To memorise setting press simultaneously the Delicate (Schon) and Time
(Zeitwahl) buttons or turn knob to Off (Aus) position
1. Turn the programme selector to any programme.
2. Press simultaneously the Long anti-crease (Knitterschutz Plus) and Time
(Zeitwahl) buttons and hold down for approx. 5 seconds.
The current setting is on the display:
– Water reservoir (Behälter) diode flashes and display shows
warning message is off
– Water reservoir (Behälter) diode steady and display shows
warning message is switched on
3.92 / 125 (7 kg load pre-drained at 1000 rpm)
3,75 (7 kg load pre-drained at 1200 rpm)
3,60 (7 kg load pre-drained at 1400 rpm)
3,20 (7 kg load pre-drained at 1800 rpm)
3.34 / 107 (7 kg load pre-drained at 1000 rpm)
1.33 / 48 (3 kg load pre-drained at 1200 rpm)
Implementation
If you were not able to remedy the problem your-
self, please contact the Customer Care Depart-
ment or one of our service partners.
electrolux 63
Value
-
-