Electrolux TW SL6 E User Manual page 11

– anti-crease phase start and end
– cycle interruption
– error
When active the symbol
TIME (Zeitwahl)
Operates only with TIME PROGRAMME
(Zeitprogramme). Allows to set individual
time of drying from minimum 10 min. to max-
imum of 3 hours (in 10 min. steps).
1. Turn the programme knob to the TIME
PROGRAMME.
2. Press the TIME button repeatedly until
the desired programme duration is
shown in the display, e.g.
gramme of 1 hour and 20 minutes.
DELAY START (Zeitvorwahl)
Allows to delay the start of a drying pro-
gramme from minimum of 30 min. to
maximum of 20 hours.
1. Select the drying programme and addi-
tional options.
2. Press the DELAY START button repeat-
edly until the desired delay start is shown
in the display, e.g.
has to start after 12 hours.
3. To activate the delay timer, press the
START PAUSE (Strat/Pause) button.
Time to start elapses in the displayed.
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme knob. The child
lock can be activated or deactivated by hold-
ing down the LONG ANTI-CREASE and
BUZZER buttons simultaneously for 5 sec-
onds.
– Before programme is started: Appli-
ance cannot be used
– After programme is started: Pro-
gramme in operation cannot be
changed
The padlock symbol
play to indicate that the child safety device is
activated.
The child safety device is not deactivated
once the programme comes to an end.
is on.
for a pro-
if the programme
appears in the dis-
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the START PAUSE button (6). The pro-
gramme is started.
The programme progress is shown in LCD
by appropriate set of icons. From left to the
right, from iron dry
depends on the drying cycle chosen. E. g. in
case of cupboard dry programme the follow-
ing status icons are visible:
Current cycle progress is marked by flashing
dash under status icon. When appropriate
part of drying cycle is accomplished dash
becomes steady and appears flashing under
next status icon.
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
OFF (Aus) and then reset the programme.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob, the programme
progress display and the maintenance
indicators flash. If an option (excluding
the buzzer ) is set, Err appears in the
multidisplay. The drying programme is
not however affected by this (laundry
protection).
Programme complete / Laundry
unloading
Once the drying cycle is complete, display
shows a blinking
icon appears dash. If the buzzer option has
been set, an acoustic signal sounds intermit-
tently for about one minute.
electrolux 11
to anti-crease
, under anti-crease
icon
.