Installation - Electrolux TW SL6 E User Manual

Condenser dryer with heat pump
Hide thumbs Also See for TW SL6 E:
Table of Contents

Advertisement

Available languages

Available languages

18 electrolux
Parameter
Weight when empty
Loading volume (depends on programme)
Voltage
Required fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-spun at
2)
1000 rpm)
Average annual energy consumption
Use
Permissible ambient temperature
The consumption values have been established under standard conditions. They may deviate when
Programme
COTTON CUPBOARD DRY
3)
COTTON IRON DRY
SYNTHETICS CUPBOARD DRY
1) Different loading volume data may be needed in some countries as a result of different measuring
methods.
2) in accordance with EN 61121
3) Hints for test institutes: cycle has to be checked in accordance with EN 61121

Installation

Transporting the appliance
Important! Only tip the appliance on its left
side to transport (see illustration), if it cannot
be transported in an upright position.
Warning! If the appliance was not
transported in an upright position, leave
it to stand for 12 hours before
connecting it to the electricity supply and
using it for the first time, so that the oil
can flow back to the compressor.
Otherwise the compressor could be
damaged.
1)
Consumption values
the machine is operated in domestic circumstances.
3)
3)
approx. 60 kg
max. 7 kg
220-230 V
6 A
1350 W
A
2.4 kWh
160.9 kWh
Domestic
+ 5°C to + 35°C
Energy consumption in kWh / average drying
time in min.
2.4/ 130 (7 kg load pre-spun at 1000 rpm)
2.3 (7 kg load pre-spun at 1200 rpm)
2.2 (7 kg load pre-spun at 1400 rpm)
2.0 (7 kg load pre-spun at 1800 rpm)
1.8/ 105 (7 kg load pre-spun at 1000 rpm)
0.75/ 50 (3 kg load pre-spun at 1200 rpm)
Appliance positioning
• It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all round
the appliance. Do not obstruct the front
ventilation grille or the air intake grilles at
the back of the machine.
• To keep vibration and noise to a minimum
when the dryer is in use, it should be
placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is.
Value

Advertisement

Chapters

Table of Contents
loading

Table of Contents