Machine Settings - Electrolux TK GL5 E User Manual

Average annual energy consumption
Use
Permissible ambient temperature
The consumption values have been established under standard conditions. They may deviate when
Programme
COTTON CUPBOARD DRY
COTTON IRON DRY
SYNTHETICS CUPBOARD DRY
1) Different loading volume data may be needed in some countries as a result of different measuring
methods.
2) in accordance with EN 61121

Machine settings

Setting
Buzzer permanent on/off
Water hardness
Water contains, a variable quantity
of limestone and mineral salts of
which quantities vary according to
geographical locations thus vary-
ing its conductivity values.
Relevant variations of the conduc-
tivity of the water compared to
those prefixed by the factory could
slightly influence the residual hu-
midity of the laundry at the end of
the cycle. Your dryer allows you to
regulate the sensitivity of the drying
sensor based on conductivity val-
ues of the water.
Consumption values
the machine is operated in domestic circumstances.
2)
2)
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (Schon) (1) and
3. The buzzer is by default always off. You can use the
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (Schon) (1) and
3. Press the START PAUSE (Start / Pause) button (6) se-
4. To memorize setting press simultaneously the DELI-
282 kWh
Domestic
+ 5°C to + 35°C
Energy consumption in kWh / average drying
4.48 / 135 (8 kg load pre-drained at 1000 rpm)
4.3 (8 kg load pre-drained at 1200 rpm)
4.0 (8 kg load pre-drained at 1400 rpm)
3.5 (8 kg load pre-drained at 1800 rpm)
3.8 / 108 (8 kg load pre-drained at 1000 rpm)
1.3 / 45 (3 kg load pre-drained at 1200 rpm)
Implementation
SENSITIVE (Sensitiv) (2) buttons and hold down for ap-
prox. 5 seconds.
– diode above BUZZER (Signal) button (4) starts lighting
- buzzer permanently on.
– lighting diode comes off - buzzer permanently off.
BUZZER (Signal) button (4) to activate or deactivate
sound but the machine does not memorize your selec-
tion.
TIME (Zeitwahl) (5) buttons and hold down for approx. 5
seconds. The current setting is on the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
quentially until you set desired level.
CATE (Schon) (1) and TIME (Zeitwahl) (5) buttons or turn
knob to OFF (Aus) position
electrolux 17
time in min.