Care And Cleaning - Electrolux TW SL6 E User Manual

Condenser dryer with heat pump
Hide thumbs Also See for TW SL6 E:
Table of Contents

Advertisement

Available languages

Available languages

12 electrolux
The drying cycles (except for the WOOL
programme) are automatically followed
by an anti-crease phase which lasts
around 30 minutes. The drum rotates at
intervals during this phase. This keeps
the laundry loose and free of creases.
The laundry can be removed at any time
during the anti-crease phase. (The laun-
dry should be taken out towards the end
of the anti-crease phase at the latest to
prevent creases from forming.) If long
anti-crease
anti-crease phase is lengthened by 60
minutes.

Care and cleaning

Cleaning fluff filters
The filters collect all the fluff which accumu-
lates during drying. To ensure that the dryer
works perfectly, the fluff filters (micro-fine fil-
ter and fine strainer) must be cleaned after
every drying cycle.
The warning lamp
this operation at the end of each cycle.
Caution! Never operate the dryer
without fluff filters or with damaged or
blocked fluff filters.
1. Open loading door
2. Use a damp hand to clean the micro- fine
filter, which is built into the lower part of
the loading aperture.
3. After a period of time, a patina due to
detergent residue on laundry forms on
the filters. When this occurs, clean the
filters with warm water using a brush.
Remove the filter from the door pulling it
out. (It can be positioned with the locat-
ing spur facing to the left or to the right).
option has been set, the
lights to remind you of
1. Open door.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care
and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF.
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
After cleaning do not forget to put it
back.
4. Push down the unlock button on the
large mesh filter.
The large mesh filter pops up.
5. Take out fine filter.

Advertisement

Chapters

Table of Contents
loading

Table of Contents