Electrolux TW SL6 E User Manual page 14

14 electrolux
3. Slide the outlet connections in and refit
the water reservoir.
If the programme has been interrupted as
a result of the water reservoir being full:
Press the Start/Pause button to continue
the drying cycle.
The water reservoir has a volume of ap-
prox. 4 litres. This is sufficient for around
7 kg of laundry which has previously
been spun at 1000 revolutions / minute.
The condensed water can be used as
distilled water, e.g. for steam ironing.
However it must first be filtered (e.g. with
a coffee filter) to remove any residue and
small pieces of fluff.
Cleaning heat exchanger filter
If the warning lamp
the heat exchanger fluff filters in the base of
the appliance must be cleaned, i.e. after each
5 drying cycles. Both filters are located in the
appliance base.
Water can collect in the filter housing
therefore it is normal for the heat ex-
changer fluff filters to become wet.
Important!
• Never operate the dryer without the fluff fil-
ters.
• Clogged filters cause higher energy con-
sumption (drying cycle elongation) and
dryer damage.
• A dirty heat pump can only be cleaned up
by means of a costly process.
heat exchanger lights,
1. Open door in plinth: To do this, press the
release button on the right and open the
door in the plinth to the left.
2. Pull the filter housing out of the base by
the handle.
1
3. To clean the fluff filter: Remove filter from
filter housing. To do this, press the pres-
sure points on the sides and pull the filter
frame up and out of the housing. Remove
fluff from the fluff filter with a damp hand.
2
1