CAME XVP S Configuration Manual page 7

LED and sensor enabling
❻
LEDS AND SENSORS
PROXIMITY
❶
Screen activation
❷
Sensibility
Mid
BEACON
Activation
❹
LED brightness
High
Pulsation in stand-by
Network settings
NETWORK
❶
Static
Mode
DHCP
IP address
Static
Netmask
Gateway
DNS
MAC address
Save
❶ Enable the screen activation in proximity to the device.
If the function is not enabled, the screen can only be activated by touch.
❷ Set the sensitivity of the proximity sensor: low (short distances), medium or high (maximum distance).
The proximity sensor distances may vary slightly depending on the person and the direct lighting conditions
of the device.
❸ Activate or deactivate the video camera LEDs. If the LEDs are active, the LED Brightness and Pulsation
in stand-by configuration is applied.
❹ If the LEDs are active, set the intensity of the LED crown on the video camera during a call.
❺ Activate the pulsating effect of the LED crown on the video camera when the device is in standby mode.
❻ Go back to the previous page.
❸
❺
Mode
IP address
Netmask
Gateway
DNS
MAC address
❻
NETWORK
Static
❷
❸
❹
❺
❼
Save
❶ Choose the type of addressing.
DHCP
The device's IP address is assigned by the DHCP
server.
If the device is configured as the master (serverless
system), make sure that the DHCP server always
assigns the same IP address to the device.
STATIC
The device's IP address is assigned manually.
❷ Enter the device's IP address.
The device IP address must belong to the
same subnet as the router and the other connected
devices.
If there is also a DHCP server, the selected
static address must not be one of those included
in the DHCP pool.
❸ Specify the correct netmask, where different
from the default setting.
❹ Specify the default gateway for your network.
❺ Enter a valid DNS address for CAMEConnect
connection.
❻ Go back to the previous page.
❼ Save the configuration.