CAME XVP S Configuration Manual page 23

CONFIGURATION AND COMMISSIONING VIA PCS/XIP
The device is part of a set-up based on an Xip system.
The system structure must be built using PCS/XIP software.
Create the system structure according to need.
❶ Enter the entry panels by dragging the XVP modules from the list on the right.
❷ Select the devices entered and complete the properties ❸.
The ID and IP address fields are mandatory ❹ ❺.
❻ Add the accessory modules, if required, such as the MTMRFID module, and any relay activation events.
Complete parameter configuration for the XVP device and the other devices.
Proceed with system programming.
XVP properties
First name
Address
ID
Addressing mode
IP address
Conversation time (s)
The "Ring time" is the maximum time for which the entry panel will ring while
waiting for an answer.Where the call is diverted, this timeout restarts with each
diversion. It must be longer than the "Ring time with diversion" confi gured on the
server.
Ring duration (s)
Always send AUX
SIP username
Door opening time (s)
Dusk notifi ed by
Door open alarm time (s)
Door open contact
Aux. lift management
Door release input notifi cation
Customise tones
Door status
Active plate
<None>
Not active
Normally open (NO)
No event
Disabled (default)
Door status (default)
Active plate (default)