Table of Contents
Advertisement
2. With both hands, grasp the sides of the oven door at its middle.
3. Rotate the door by approximately 70 ° until the hinges can be taken out completely from the hinge
holes.
Reinstalling the door
1. With the clips still flipped open, align the door hinges into the hinge holes.
2. Rotate the door toward the horizontal line and flip the clips closed.
Changing the oven light (danger of electric shock)
Before replacing the oven light bulb, take the following steps
● Switch off the oven
● Disconnect the oven from the mains supply
● Protect the oven light bulb and the glass cap by laying a cloth on the bottom of the
oven.
Replacing the oven side lamp and cleaning the glass cap
1. To remove the glass cover, hold the lower end with one hand, insert a flat sharp
implement such as a table knife between the glass and the frame and pop out the
cover.
2. If necessary, replace the halogen bulb with a 25 watt, 230 V, 300 °C heat - resistant oven light
bulb. Always use a cloth or tissue paper to hold the halogen bulb when inserting. This will stop oil
deposits from your fingers transferring on to the surface of the bulb.
3. Replace the glass cover.
Sometimes simple things can appear to be a problem with the product. The FAQ,s below are
offerred as a guide to help before calling Parmco.only. If you need extra advice please contact
Parmco on (09) 573 5678 or sales@parmco.co.nz. Please have your serial number and proof or
purchase ready as these will be needed to initiate any service call.
TROUBLESHOOTING
- 21 -
Advertisement
Table of Contents
