Parmco PPOV-6S-MULTI-1 Installation And Operating Instructions Manual page 21

Table of Contents

Advertisement

Oven accessories
Wash all roasting trays and wire racks and other accessories after each use and dry with a kitchen
towel. To clean easily, soak in warm soapy water for about 30 minutes.
Catalytic Liners
The removable catalytic liners are coated with a dark gray catalytic enamel that can become coated
with oil and fat distributed by circulating air during convection heating. These deposits will burn off at
oven temperatures of 200 °C and higher, for example, when baking or roasting.
Higher temperatures will result in faster burning. The oven and accessories should be cleaned after
each use. Otherwise further baking and roasting will cause the deposits to bake on even harder and
cleaning may become difficult and in extreme cases impossible.
Cleaning by hand. Make sure the oven is cool before cleaning.
The catalytic liners should be cleaned using a solution of hot water and washing-up liquid applied
with a soft nylon brush. Do not wash these liners in the dishwasher.
Do not use abrasive cleaning agents, hard brushes, scouring pads or cloths, steel wool, knives or
other abrasive materials. Do not use oven spray on catalytic enamel as the chemicals used in oven
sprays will damage catalytic liners and render them unusable.
If using oven sprays on the interior oven surfaces, the catalytic liners must first be removed from the
oven.
Cleaning with high temperatures
Before cleaning the catalytic liners using high oven temperatures make sure that all interior oven
surfaces have been cleaned as described above. Otherwise, the high temperatures can bake deposits
onto the interior oven surfaces and make them impossible to remove.
Note that deposits of spices, syrups and similar substances are not removed by this process. These
should be removed by hand with a mild solution of hot water and washing-up liquid applied with a
soft brush.
● Remove all accessories from the oven.
● Set the oven to conventional function.
● Set the heat to 250 °C.
● Run the oven for approximately 1 hour. The length of time will depend on the degree of soiling.
It is a good idea to set the finish time for the process using the end time setting, in case you forget to
switch the oven off at the end.
Any remaining soil will gradually disappear with each subsequent use of the oven at high
temperatures. The stains on the catalytic liners caused by grease, fats and oils from cooking are
completely normal and will not be able to be completely removed. Catalytic liners are a consumable
item and can be replaced with new catalytic liners.
Removing the door
1.Flip open the clips at both hinges to the "locked position".
- 20 -

Advertisement

Table of Contents
loading

Table of Contents