Suzuki SMD16 Operator's Manual page 40

1.9.7 How to use the data box as the display for the FURUNO SC-33
When a FURUNO SC-33 Satellite Compass
can use a box in the data area as a dedicated SC-33 display.
Note: This function requires PGN 130578 Vessel Speed Components to be output
from the SC-33.
Referring to section 1.9.2 and section 1.9.3, select the 3-Axis Speed display.
The uppermost speed indication is the speed at the CCRP. The CCRP is set and
installation.
The middle speed indication is the speed at mid-ship.
The lowermost speed indication is the speed at the stern
Note 1: To correctly display directional indications and speed indications, the follow-
ing are required:
• Heading: when a valid heading is not input, wind and tidal current indications are
not shown. Further, speed is indicated as blank "----" and the compass directions
(N,S,E,W) are not shown.
• Connection to a rate gyro or gyrocompass: when there is no signal received from
the rate gyro or gyrocompass, the aft speed is indicated as blank "----".
3-Axis speeds show the speed at
the CCRP, mid-ship and stern.
The CCRP, set at installation, is
either the bow, transducer
location, or center of the vessel.
Directional indicators
The directional indicators show which direction the boat is travelling.
: Indicates speed in the fore/aft direction.
: Indicates transverse (port/starboard) speed.
1. SYSTEM INTRODUCTION
™
is connected to the same network, you
Wind direction
( purple arrow )
Tidal current direction
( brown arrow )
1-23