Video Signal Type; How To Set The Video Display; How To Set The Video Signal - Suzuki SMD16 Operator's Manual

11. CAMERA/VIDEO/FUSION-Link
11.2

Video Signal Type

There are five types of video signals which can be connected to this equipment.
• Analog signal: Images from surveillance cameras, on-board cameras and video
playback.
• Digital signal (IP): Images from a network camera.
Note: Turn on the network camera first, then turn on the MFD.
• Axis Quad Server: The image from an Axis Quad Server, which can feed up to four
lines of video signals simultaneously.
• FLIR: Images from a FLIR brand infrared camera
11.3

How to Set the Video Display

11.3.1

How to set the video signal

Video Input 1/Video Input 2 (analog, FLIR)
Connected: Turn on to use the device (video equipment, FLIR camera) connected to
the VIDEO-IN1, VIDEO-IN2 port.
Nickname: If desired, you change the name of the analog camera(s). The default
names are [CAMERA1], [CAMERA 2]. You can use a maximum of 20 characters. To
change a name, tap [NickName] to show the software keyboard. Change the name,
then tap [] to finish. The name is reflected to the following locations.
• The name that appears at the bottom right corner of the camera display.
• Home screen[Settings][Camera][FLIR Installation][Video Source]
• Pop-up menu that appears when you tap the camera display.
IP camera
The IP address and the signal name for the IP camera signal can be changed as
shown below. Additionally PTZ control can be turned on or off.
Note: [PTZ Control] should only be used when the connected camera is compatible
with the PTZ function. Activating the [PTZ Control] function when the camera is not
compatible may cause problems with this equipment's regular functions.
11-2