Suzuki SMD16 Operator's Manual page 305

14. OTHER FUNCTIONS
Menu item
[Create New QR Code]
[View QR Code Logs]
[Reset Data...]
[Installation...]
NETWORK SENSOR SETUP section
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the appropriate operator's manual, supplied with
the sensor.
CALIBRATION section
Menu item
[Heading] Offset heading data.
[Speed Through Calibrate speed data. Enter amount in percentage.
Water]
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50° to +50°
[Wind Angle] Offset wind angle data.
[Sea Surface Offset sea surface temperature data.
Temperature]
DATA DAMPING section
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed&Angle]
[Rate of Turn]
FUSION section
Menu item
[Connect to Fu- Connect to your Fusion equipment.
sion]
[Fusion Auto Set to [ON] to allow this unit to control the Fusion volume.
Volume]
[Minimum Set the minimum speed threshold. Exceeding this
Speed] speed activates volume auto control.
[Maximum Set the maximum speed threshold.
Speed]
[Volume In- Set the amount of extra volume to output.
crease]
14-8
Description
To create new QR Code.
To read out the recorded data .
To reset the data.
Menu for qualified technician only.
Description
Description
Set data damping time. The lower the set-
ting the faster the response to change.
Description
Options (setting range)
Options (setting range)
-180.0° to +180.0°
-50° to +50°
-180.0° to +180.0°
-10° to +10°
Options (setting range)
0 to 59 seconds
Options (setting range)
0.0 kn to 19.9 kn
0.1 kn to 99.0 kn
10% to +50%