Suzuki SMD16 Operator's Manual page 304

IF-NMEAFI SETUP section
Menu item
[Select IF] Select [IF-NMEAFI] to set the analog data that is input from the IF-NMEAFI.
[Category] Select the category for the analog sensor to
set.
[Resistance Full] The resistance, in Ohms, when the tank is full. 0 (ohm) to 300 (Ohm)
[Resistance Mid] The resistance, in Ohms, when the tank is half
full.
[Resistance Empty] The resistance, in Ohms, when the tank is
empty.
[Capacity] The capacity of the tank.
[Self test] Test results are displayed.
Resets the converter selected at
[Set Hardware To
[Select IF] to factory default.
Factory Default]
DATA ACQUISITION section
Menu Item
[GP330B WAAS Mode]
[WS-200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
[NMEA 2000 PGN Output] Select [ON] for the PGNs (Parameter Group Number, CAN bus
[Sky View]
INTERNAL GPS SETUP section
Menu Item
[WAAS Mode]
FURUNO SC-30 SETUP section
Menu item
[WAAS Mode] Select [ON] to use the WAAS mode.
[Heading Offset] Enter the offset value for heading.
[Pitch Offset] Enter the offset value for pitching.
[Roll Offset] Enter the offset value for rolling.
Engine SETUP section
Menu item
Diagnosis
Description
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. (FURUNO sensors are shown at the upper part of the list.)
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
Select [ON] to output NMEA sentences.
(NMEA2000) message) to output from the CAN bus port.
Show the condition of GPS and GEO (WAAS) satellites
on the [GPS SkyView] display. The bearing and eleva-
tion angle of all GPS and GEO satellites (if applicable) in
view of your receiver appear. For the serviceman.
Note: The [GPS SkyView] display can also be shown by
tapping the GPS icon (shown right) on the home screen.
Set to [OFF] when using external GPS.
Description
Description
To open the [Alarm] menu and display the activated
alarm.
14. OTHER FUNCTIONS
Options (setting range)
[Wind], [ST800_850], [Fuel],
[FreshWater], [WasteWater],
[LiveWell], [Oil], [BlackWater]
0 (ohm) to 300 (Ohm)
0 (ohm) to 300 (Ohm)
0 (G) to 2650 (G)
[OK], [Cancel]
Options (setting range)
[ON], [OFF]
Description
Options (setting range)
[ON], [OFF]
-180° to +180°
-90° to +90°
-90° to +90°
Options (setting range)
14-7