4.12.2
Hold the slope
iCON grade iCP42, 3D Run Mode
Holding Slopes
There are two ways to hold the slope when working with an MBS:
• Above the element that the blade is currently positioned over.
• Hold the slope for a specific element by choosing the element's code. Remember that
the element must be coded when creating the MBS in order for this function to be avail-
able.
In run mode, press Lock to hold the slope. The key
turns green when the function is activated.
• The slope above the current element will automat-
ically be held if none of the settings below are
adjusted.
• The slope will be held for a certain code if acti-
vated. See "Holding slope for an element using a
code", page 84, for more information.
83