Sensors - Leica iCON grade iCP42 User Manual

3.7
How to set 3D sensor
type
iCON grade iCP42, Operation
3D Sensors
Select 3D Height (press the left or right (sensor) key once), and then press the Adjust
function key to enter the adjust menu.
Note that it's only the current selected sensor in either left or right side that is
adjusted.
If the 3D system is configured to indicate which sensor is currently in use, select AUTO.
If not, then select either TRACKER or GPS from the menu.
Once Auto / GPS / Tracker is selected, it is required to EXIT from this menu for the change
to take effect and then re-enter the menu to adjust gains.
Gains need to be set for both GPS or Tracker depending on which sensor is used. If AUTO is
selected, the iCP42 will use the gains set in the Tracker and GPS settings.
Use the right arrow key to enter the gains settings.
Refer to chapter "3.8 Setting the Value for Gain and Deadband" for configuring Gains.
45