Blade Reference Point And Hydraulic Control Point; Selecting Blade Reference Point And Hydraulic Control Point - Leica iCON grade iCP42 User Manual

4.6
Blade reference point
and hydraulic control
point
4.7
Selecting Blade refer-
ence point and
Hydraulic control point
iCON grade iCP42, 3D Run Mode

Blade reference point and hydraulic control point

There are two different points on the blade that functionalities relate to that are selectable:
• Blade reference point (Left blade edge, below the centre or right blade edge). Distance
to guide line and storing points refer to this point. In the graphics this point is illustrated
with a yellow cross.
• Hydraulic control point (left blade edge, centre of the blade or right blade edge). Height
difference and target cross slope for automatic blade control are taken below this point.
In the graphics this point is illustrated with a yellow triangle.

Selecting Blade reference point and Hydraulic control point

This functionality is used to decide what part of the blade should be used as reference for
3D models. This setting is applicable to both single and dual antenna solutions.
1. Press Tools.
2. Select Blade Settings.
71