Swap Function - Leica iCON grade iCP42 User Manual

iCON grade iCP42, Operation
3.4.3
Set up and operation
Level 1

Level 2


Swap Function

The swap function allows the operator to quickly and easily swap sensors, turn the machine
around, and grade in the opposite direction by following the previously pass.
There are two levels to the swap function available:
• Level 1: Swap the cross slope by inversing the actual target cross slope. For example:
+2,3% -> -2,3%.
• Level 2: Swap the cross slope by inversing the actual target cross slope and swap the
side of the Grader that is controlled by ultrasonic.
By pressing / SWAP the actual target slope will be inversed.
The SWAP function can also be activated by pressing the up key on both external multi
switches simultaneously.
Requirements: Two Tri-Sonic sensors must be connected and the system must be in Grader
mode.
1. Move the Grader to a flat level ground.
2. Set the moldboard level with the machine.
3. Select slope on left side and sonic on right side. Choose ground mode for the Tri-Sonic.
4. Manually set the cross slope of the blade to level.
5. Set the height for the right sonic by pressing and holding
6. Press / SWAP and the sensors will switch sides.
7. Set the height for the left sonic by pressing and holding
The machine is now ready for the final grade following the previously pass.
It is possible to have different heights and mode settings for the two Tri-Sonic sensors.
/ SEEK for 2 sec.
/ SEEK for 2 sec.
40