Procom FBNSD400T-ZC Series Owner's Operation And Installation Manual page 18

4. Install pins on log #4 onto the two slots
in the front bracket (see Figure 16 and
Figure 18).
5. Insert the recessed hole on the bottom of
log #5 onto the pin on log #2 (see Figures
18 and 19).
Pin for Log #5
Log #4
Figure 18 - Installing Log #4
CAUTION: Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installa-
tion may void the warranty on the product.
• For long periods of non-operation, remove
batteries from all components for safety.
Unscrew ignitor cap and install a AAA battery
with the + pointing out. Replace cap.
18
INSTALLATION
Hole for Log #6
INSTALLING BATTERIES
www.usaprocom.com
6. Insert the pin on log #6 into the hole on
log #3 (see Figures 18 and 19).
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Log #5
Figure 19 - Installing Log #5 and #6
AAA
Battery
Positive
UP
Figure 20 - Installing Battery in Ignitor
Log #6
200348-01C