Procom FBNSD400T-ZC Series Owner's Operation And Installation Manual page 4

WARNING: Do not place
clothing or other flammable
material on or near the appliance.
Never place any objects in the
heater.
WARNING: Due to high
temperatures, the appliance
should be located out of traffic
and away from furniture and
draperies.
WARNING: Heater becomes
very hot when running. Keep
children and adults away from
hot surfaces to avoid burns
or clothing ignition. Heater
will remain hot for a time after
shutoff. Allow surfaces to cool
before touching.
WA R N I N G : C a r e f u l l y
supervise young children when
they are in the room with the
heater.
WARNING: Make sure a
fireplace screen is in place
before running heater.
1. Do not place propane supply tank(s)
inside any structure. Propane supply
tank(s) must be placed outdoors.
2. This heater should not be installed in a
bedroom or bathroom.
3. This heater needs fresh air ventilation to
run properly. This heater has an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS shuts down the heater
if not enough fresh air is available. See Air
for Combustion and Ventilation, page 7.
If heater keeps shutting off, see Trouble-
shooting, page 24.
4. Keep all air openings in front and bottom
of heater clear and free of debris. This will
ensure enough air for proper combustion.
5. If heater shuts off, do not relight until you
have provided fresh, outside air. If heater
keeps shutting off, have it serviced.
4
SAFETY
6. Do not run heater:
• Where flammable liquids or vapors are
used or stored.
• Under dusty conditions.
7. Before using furniture polish, wax, carpet
cleaner, or similar products, turn heater off.
If heated, the vapors from these products
may create a white powder residue within
burner box or on adjacent walls or furniture.
8. Always run heater with control knob at
PILOT/IGN or ON (1 thru 5) positions.
never set control knob between locked
positions. Poor combustion and higher
levels of carbon monoxide may result.
9. Do not use heater if any part has been
under water. Immediately call a qualified
service technician to inspect the room
heater and to replace any part of the
control system and any gas control which
has been under water.
10. Turn off and unplug heater and let cool
before servicing. Only a qualified service
person should service and repair heater.
11. Operating heater above elevations of
4,500 feet could cause pilot outage.
12. To prevent performance problems, do not
use propane fuel tank of less than 100 lbs.
capacity.
13. Do not use this heater as a wood-burning
heater. Use only the logs provided with the
heater.
14. To prevent the creation of soot, follow the
instructions under Care and Maintenance
page 22.
15. Do not add extra logs or ornaments such as
pine cones, vermiculite, or rock wool. Using
these added items can cause sooting.
Do not add lava rock around base. Rock
and debris could fall into the control area
of heater. After servicing, always replace
screen before operating heater.
16. This log heater is designed to be smokeless.
If logs ever appear to be smoking, turn off
heater and call a qualified service technician.
NOTE: During initial operating, slight
smoking could occur due to log curing and
heater burning off manufacturing residues.
17. Solid fuels should not be burned in
fireplace in which a vent-free log set is
installed. Do not use this heater to cook
food or burn paper or other objects.
18. Do not use this heater if any log is broken.
Do not operate heater if a log is chipped
(dime-size or larger).
www.usaprocom.com
200348-01C