Procom FBNSD400T-ZC Series Owner's Operation And Installation Manual page 10

This appliance is factory
preset for propane gas. No
changes are required for
connecting to propane. Only
a qualified installer or service
technician can perform gas se-
lection and connecting to gas
supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited.
CAUTION: To avoid gas leak-
age for the gas not being used at
the inlet of regulator, a qualified
installer or service technician
must use supplied cap.
You will notice a color coded
plunger on the inside of the regula-
tor. This is normal. When the inlet
connection fitting is inserted
and tightened, this plunger will
be pushed back by the fitting
making all of the adjustments
for the gas being supplied. DO
NOT REMOVE THE PLUNGER.
The regulator will not work and
the warranty will be voided.
The inlet regulator is color coded
for identification of the correct
gas type. Blue is for propane (LP
gas) and yellow is for natural gas.
10
INSTALLATION
GAS SELECTION
Insert Gas Fitting
for Propane Gas
Blue Propane
Gas Plunger
Apply thread sealant to the threads on the
connection fitting. While pushing in, rotate
the fitting clockwise until the threads engage
the regulator. After the fitting has been hand
tightened into the regulator use a wrench to
complete tightening of the fitting. Install ad-
ditional fitting to connect to the house supply.
www.usaprocom.com
Yellow Natural Gas
Plunger Underneath
Metal Cap
Figure 4 - Gas Regulator
FOR PROPANE GAS
INSTALLATION: BLUE
DO NOT REMOVE
Blue Propane Plunger
Install Gas Fitting Here
Insert Gas Fitting
for Natural Gas
200348-01C